CHRYSLER

CHRYSLER

Teksti on käännetty käyttämällä Google Translate online,siksi saa esintyä virheitä.Käännöksen alkuperäinen kieli on englanti,katsomaksi alkuperäistä vaihtaa kieli tässä.

Alkuperäisen kielen valinta

Osat

Code Osanumero DescriptionMarket Ajoneuvon tyyppi Series Moottorin BODY Transmission LEIKATA Kpl Tilalle Vaihtoehtoisia osia Yleissopimusten Service korjaus vinkkejä
TWO DIFFERENT MAKE DRIVE SHAFTS ARE BEING USED ON FRONT WHEEL DRIVE VEHICLES, GKN & CITROEN. SERVICE REPLACEMENT PARTS ARE NOT INTERCHANGEABLE.US
NOTE: M&Z W/1.7 ENG. & VW-A412 4 SPEED MANUAL USES GKN SHAFT W/BOLTED FLANGE TYPE INNER JOINT ATTACHED BY 6 SCREWS.US
CAUTION: SOME P&D MODELS MAY HAVE A GKN ON ONE SIDE AND CITROEN ON THE OTHER. TO AVOID PROBLEMS, THE MAKE OF SHAFT MUST BE DETERMINED PRIOR TO SPECIFYING PARTS.US
THE ACCOMPANYING FIGURE ILLUSTRATES THE CHARACTERISTICS OF THE TWO MAKES OF SHAFT.US
1 SHAFT COMPLETE, LT.US
1A GKNUS
1B CITROENUS
1B THE APPEARANCE OF RT. SHAFTS IS THE SAME AS THE LT. EXCEPT FOR OVERALL LENGTH AND THE RT. INNER JOINT STUB SHAFT IS LONGER AND INCLUDES THE SPEEDOMETER DRIVE WORM.US
2 BOOT, INNER JOINTUS
2A GKN = 2 CONVOLUTIONS AT INNER ENDUS
2B CITROEN = 3 CONVOLUTIONS AT INNER ENDUS
3 SHOULDER, INNER JOINT O.D. TO INNER FACEUS
3A GKN = BEVELEDUS
3B CITROEN = ABRUPT (APPROX. 90 DEGREE)US
4 OUTSIDE DIAMETER, INNER JOINTUS
4A GKN = APPROX. 77MM (3.0")US
4B CITROEN = APPROX. 85MM (3.375")US
5 SHOULDER, OUTER JOINT O.D. TO SEAL SURFACEUS
5A GKN = CURVED FROM O.D.US
5B CITROEN = FLAT BEVEL WITH SHARP ANGLE AT O.D.US